Screws and Drill & Tap Set
Stainless Steel Screws are designed for use with both Cast Cleats and Flagpole Top Adaptors. Drill and Tap Kit contains bit and 5/16-18NC Tap.
For Use With Outrigger and
Vertical Wall Mount
The Wall Anchorage Kit consists of a 3/4″-10NC x 18″ Stainless Steel through bolt, 3/4″ Stainless Steel Nuts, Spring Lock Washers, Flat Lock Washers, and 1-1/4″ x 14″ Schedule 10 Aluminum pipe. Each Kit contains one (1) bolt.
*Note: These products are offered as component pieces only. Installation methods should always be approved by a Structural Engineer based on individual jobsite variables.
Outrigger Retainer Kit
The Outrigger Retainer Kit allows the tension on the halyard to be relieved, facilitating both the raising and lowering of the flag while providing a way to unfurl a flag wrapped around an Outrigger Wall Mount Shaft. The system is offered as a complete kit containing the Pulley Block (attachment hardware by others), 75′ HAL-0710-WHT Halyard, CLA-9090 9″ Cleat, TMB-0200 Stainless Steel Yoke, CRP-0520 Aluminum Crimp, and LNK-0300 Connecting Link.
Pulleys / Eyebolt
Single and Double Swivel
Pulleys are constructed of zinc-plated housings, nylon pulleys and brass connecting pins. Eyebolt is 3/8″-16NC x 4-3/4″ Long Stainless Steel.
Formulated to remove oxidation stains from aluminum without the use of abrasives or wire brushing. One Gallon container requires no mixing.
Touch Up Paint
Touch-Up Paints from Concord American Flagpole contain the highest quality spray paint custom matched to our most popular Powder Coat color.
Powder Coat Finish Options
BZT = Powder Coat – BronzeTone
BLK = Powder Coat – Black
WHT = Powder Coat – White